Blog /at_ems_factory /The EMSPROTO Dry Cabinet
The EMSPROTO Dry Cabinet

3/12/2019
EMSPROTO dry cabinet used to store completed prototypes prior to shipment.
This article is available in the following languages :Français

EMSPROTO continually invests in means to guarantee the best possible quality.
The Dry Cabinet is one of the latest equipments that has just joined our factory.


WHAT IS IT USED FOR ? 


This equipment makes it possible to preserve the PCBs after they passed the dry cabinet if they are not brazed within 24 hours in order to avoid any resumption of moisture.

MSL (Moisture Sensitivity Level) components are also stored in this cabinet if they are deconditioned from their Drypack protecting them from moisture.


armoire-seche3

WHY ?  

PCBs or some components are made of porous materials (fiberglass, ceramic, …) and can store moisture.

This moisture is vaporized during reflow due to the rapid rise in temperature above 217 ° C. This mechanical expansion, amplified by the fact that the temperatures reached are higher than the glass transition temperature of plastic materials, so at a point where its coefficient of expansion increases sharply, causes delamination of the component (cracks) or PCB.

To avoid this problem the PCBs are dried before assembly and the components are supplied by the manufacturers in Drypack packaging (bag with moisture barrier + desiccant sachets). If the Drypack packaging is open, it is imperative that the components be brazed in a limited time, then re-plunged and returned to Drypack or stored in a dry cabinet. If the Drypack has been open for too long (floor life exceeded) a revisit of the components in the Dry Cabinet is necessary.

Drypack Packaging

dry-pack

fichier-199 Zoom MSL (Moisture Sensitivity Level)


MSL (Moisture Sensitivity Level), moisture sensitive components are identified by manufacturers by a level called MSL (Moisture Sensitivity Level) that ranges from 2 to 6, the higher the level the higher the sensitivity of the component. The components most often concerned are BGA, Leds, Modules, …

The JEDEC J-STD-033C standard governs MSL (Moisture Sensitivity Level) levels, drying times (backing) and floor life. This is the maximum time between the opening of the Drypack and the reflow of the component.

Label Drypack

msl level EN


image-1

image

Need help ?

FAQ
Resources
Chat